Indicator Reset Light Service

    Instructions on how to manually reset the warning signs that occur in your car dashboard

    Service oil reset Toyota 4Runner

    2005-2009
    Turn the ignition to run (one position before starting engine).
    Bring up the odometer reading using the trip meter reset knob then the turn ignition off.
    Hold down knob while turning the ignition key to the run position (one position before starting engine).
    Hold down the knob until the light goes off. Before the light goes off, it illuminates for 3 seconds, flashes for 2 seconds and illuminates for 1 second. If the system fails to reset, the light will remain flashing. In this case, return to step 1 and try again.
    Turn the ignition off and then start the engine to verify the indicator has been reset.
    2010
    Start the engine and bring up the trip meter A reading.
    Vehicles with smart key system:
    Turn the “ENGINE START STOP” switch off.
    While pressing the Trip Meter reset button, press the “ENGINE START STOP” switch once (do not start engine).
    Continue to press and hold the button until the trip meter displays “000000”.

    1.Turn the ignition off and then start the engine to verify the indicator has been reset.
    Vehicles without smart key system:
    2. Turn the ignition switch off.
    3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
    4. Hold down knob for at least 5 seconds. The odometer indicates “000000” and the light goes off. If the system fails to reset, the light will continue flashing.
    5. Turn the ignition off and then start the engine to verify the indicator has been reset.

    This div height required for enabling the sticky sidebar