Nissan Frontier indicator reset service light

Nissan Frontier oil reset service light indicator, engine oil life, service indicator oil reset maintenance light Nissan Frontier, oil reset instructions:

How do you oil reset maintenance light Nissan Frontier, maintenance light, Nissan Frontier oil reset service light indicator years 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012 model years. For reset maintenance light and that can be made manually by use button on car dash board.

How do you reset service light indicator Nissan Frontier. From years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.

Speedometer Nissan Frontier.
The speedometer indicates vehicle speed in miles per hour (MPH) and kilometers per hour (km/h).
Odometer/Twin trip odometer Nissan Frontier.
The odometer/twin trip odometer is displayed when the ignition key is in the ON position.

The odometer records the total distance the vehicle has been driven.
The twin trip odometer records the distance of individual trips.

Changing the display Nissan Frontier with twin trip odometer:
For vehicles equipped with twin trip odometer, pushing the change button changes the display as follows: Trip A -> Trip B -> Trip A.

For vehicles equipped with trip computer, pushing the change button changes the display as follows:
Trip A -> Trip B -> Distance to Empty -> Average speed -> Average fuel consumption -> Journey time -> Trip A.
For additional information, refer to “Trip computer ” later in this section.

Resetting the trip odometer Nissan Frontier:
Pushing the change button for more than 1 second resets the trip odometer to zero.

TRIP COMPUTER Nissan Frontier (if so equipped).
The display of the trip computer is situated in the speedometer display. When the ignition is turned to ON, the display scrolls all the modes of the trip computer and then shows the mode chosen before the ignition switch was turned OFF. When the ignition switch is turned to ON, modes of the trip computer can be selected by pushing the trip computer change button. The following modes can be selected:

Distance to empty Nissan Frontier (dte—mile or km).
The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption.
The display is updated every 30 seconds.
The dte mode includes a low range warning feature: when the fuel level is low, the dte mode is automatically selected and the digits blink in order to draw the driver’s attention. Press the change button if you wish to return to the mode that was selected before the warning occurred. The dte mark (dte) will remain blinking until the vehicle is refueled.
When the fuel level drops even lower, the dte display will change to (—-).

NOTE:

• If the amount of fuel added while the ignition switch is OFF is small, the display just before the ignition switch is turned OFF may continue to be displayed.
• When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display.

Average speed Nissan Frontier (MPH or km/h).
The average speed mode shows the average vehicle speed since last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows (—-).

Average fuel consumption Nissan Frontier (Mpg or l/100km).
The average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. At about the first 1/3 miles (500 m) after a reset, the display shows (—-).

The full procedure how to reset service light indicator Nissan Frontier is taken from owners manual.