Indicator Reset Light Service

    Instructions on how to manually reset the warning signs that occur in your car dashboard

    Oil service reset Chevrolet GMC Trucks Suburban/Tahoe/Yukon

    How do you reset maintenance light, reset service light indicator Chevrolet GMC Trucks Suburban/Tahoe/Yukon. For reset maintenance light and that can be made manually by use button on car dash board.

    Reset service light indicator, engine oil life Chevrolet GMC Trucks Suburban/Tahoe/Yukon, oil reset instructions:

    2000-2006

    Turn the ignition to run (one position before starting engine).
    Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
    If the Change Oil Soon light flashes the system is resetting.
    Turn the ignition off and then start the engine to verify the indicator has been reset.

    2007-2010

    Turn the ignition to run (one position before starting engine).
    Display the OIL LIFE REMAINING on the DIC (i button). If the vehicle does not have DIC buttons, the vehicle must be in P (Park) to access this display by pressing the trip odometer reset stem.
    Press and hold the SET/RESET (check mark) button on the DIC , or the trip odometer reset stem if vehicle does not have DIC buttons for more than 5 seconds. The oil life will change to 100%.
    Turn the ignition off and then start the engine to verify the indicator has been reset.

    or

    Turn the ignition to run (one position before starting engine).
    Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
    Display the OIL LIFE REMAINING on the DIC. If the display shows 100%, the system is reset. If the vehicle has a CHANGE OIL SOON message this should be off.
    Turn the ignition off and then start the engine to verify the indicator has been reset.



    This div height required for enabling the sticky sidebar