Indicator Reset Light Service

    Instructions on how to manually reset the warning signs that occur in your car dashboard

    Oil service reset Jeep Commander

    Engine Oil Change Indicator System

    Oil Change Required
    Your vehicle is equipped with an engine oil change
    indicator system. The “Oil Change Required” message
    will flash in the EVIC display for approximately 10
    seconds after a single chime has sounded to indicate the
    next scheduled oil change interval. The engine oil change
    indicator system is duty cycle based, which means the
    engine oil change interval may fluctuate dependent upon
    your personal driving style.
    Unless reset, this message will continue to display each
    time you turn the ignition switch to the ON/RUN
    position. To turn off the message temporarily, press and
    release the MENU button. To reset the oil change indicator
    system (after performing the scheduled maintenance)
    refer to the following procedure.

    1. Turn the ignition switch to the ON position (Do not
    start the engine).

    2. Fully depress the accelerator pedal slowly three times
    within 10 seconds.

    3. Turn the ignition switch to the OFF/LOCK position.

    NOTE: If the indicator message illuminates when you
    start the vehicle, the oil change indicator system did not
    reset. If necessary repeat this procedure.



    This div height required for enabling the sticky sidebar